Cricut Setting Guide for cutting various materials

[Dawn]

Settings guide for favorite materials

Scrapbook Paper and Cardstock - Standard Blade Machine Settings: Speed 2 (Low), Pressure 5 (High), Blade Depth 5, Multi Cut 1

Bazzill, textured paper/cardstock - Standard Blade Machine Settings: Speed 1 (Min), Pressure 5 (Max), Blade Depth 6, Multi Cut 1

Fabric (0.023"/0.58mm thick) - Deep Blade Machine Settings: Speed 3 (Med), Pressure 4 (High), Blade Depth 5, Multi Cut 1
Note: Use a thin iron-on interfacing with the fabric, set the iron at its highest temperature setting. Apply direct heat and pressure to flocking for approximately 30 seconds. Peel protective liner when cool. Wash and dry garment inside out.

Magnet (0.035"/0.080mm thick) - Deep Blade Machine Settings: Speed 2 (Med), Pressure 5 (Max), Blade Depth 6, Multi Cut 4

Stencil (0.0155"/0.40mm thick) - Standard Blade Machine Settings: Speed 2 (Med), Pressure 5 (Max), Blade Depth 6, Multi Cut 2
Note: Adhesive is repositionable. Replace liner to protect adhesive during storage.

Chipboard (0.059"/1.50mm thick) - Deep Blade Machine Settings: Speed 3 (Med), Pressure 4 (High), Blade Depth 6, Multi Cut 5
Note: A fresh mat is needed to hold material. Small pieces of chipboard may require tape to stay in place.

Emboss (0.0160"/0.41mm thick) - Standard Blade Machine Settings: Speed 3 (Med), Pressure 5 (Max), Blade Depth 6, Multi Cut 2

Stamp (0.0415"/1.05mm thick) - Deep Blade Machine Settings: Speed 3 (Med), Pressure 4 (High), Blade Depth 5, Multi Cut 1
Note: Use a fresh mat to keep material firmly in place.

[Scrap Happy]

This comes in handy, thanks!

[Dawn]